Geeks and Nerds Stuff

Things To Remember When Installing Ethernet Cables

Wi-Fi is more ubiquitous because it doesn’t require wires to connect devices to a network, but you may choose to go with Ethernet instead. Ethernet offers better dependability because it’s less likely to experience signal interference and because it won’t disconnect unless the cables you use become damaged or separated from your computers or router. As long as you’re aware of these things to remember when installing Ethernet cables, you should have smooth Internet to use for working at home and doing leisure activities such as gaming.

Things To Remember When Installing Ethernet Cables

Think About Distance Restrictions

Since your computers must remain physically linked with Ethernet cables to maintain their connection, you should consider distance restrictions before you purchase them. You want to avoid a situation where your cables aren’t long enough to comfortably accommodate your device setup. Pay attention to the lengths available, and keep in mind that 100 meters, or about 328 feet, is the limit for most types of Ethernet cables. Past this, and the signals they carry will weaken.


Be Conscious of Cables’ Surroundings

Ethernet cables may have protective jackets, but you should still try to run them through areas where they won’t be exposed to any potentially destructive conditions. When you’re installing Ethernet cables, one thing to remember is to keep them away from locations around your house that are hot or wet or that already have other electrical wires or lines. This way, you won’t run the risk of having your cables fail unexpectedly while you’re in the middle of an important task. Your Ethernet will also be free of the risk of electrical fires.


Don’t Excessively Bend Cables

Cables are meant to bend to some degree so that you can conveniently arrange them in various spaces. You shouldn’t bend them too much, though, as this can interfere with their ability to transmit data. To figure out the maximum curvature without any negative effects, you can calculate wire bend radius and wire bend diameter. You can find formulas for both so that you never unintentionally impede your cables. You can also follow the rule of thumb for Ethernet cables, which states that U/UTP cable bends should not exceed four times the cable jacket diameter and that F/UTP cables bends should not exceed eight times that diameter.

Rate This Post